JBH D09, User Manual

Page: 17 / 44

INSTALL SETUP
Sit on the chair and Lean backwards to make sure the clip locker which located below
the seat to the rear of the D09 / D09B / D09C / D09D / D09E, to lock the seat into place.
This step is very important !!!
4.
Install the controller into the open slot on the arm of the chair, on the right side (if user
needed, can change to left side). tighten knob located under the armrest to secure the
controller in place.
5.
Connect the controller wire harness to the CPU wire harness. Take care the line up the
pins properly as arrow tip indicate, so that they do not get bent, broken or damaged.
6.
15
Photo 5. Unfold the chair into a seated position
Photo 6. Slide joystick controller
into armrest
Photo 7. Secure joystick
controller knob
Note
Make sure connector pins “white arrow” to “white arrow” .
Photo 8. Connect