Safety
- The equipment is designed to filtrate only the fumes generated by soldering.
- Do not use the units for the filtration of combustible, explosive or corrosive gasses. Incorrect use may
cause fire.
- The power plug must be plugged into approved bases. Be sure that it is properly grounded before use.
When unplugging it, hold the plug, not the wire.
- Do not leave the appliance unattended when it is on.
- Do not cover the ventilation grills. Heat can cause inflamable products to ignite.
- This appliance can be used by children over the age of eight and persons with reduced capabilities or
lack of experience provided that they have been given adequate supervision or instruction concerning
use of the appliance and understand the hazards involved.
- Maintenance must not be carried out by children unless supervised.
- Keep your workplace clean and tidy. Wear appropriate protective mask, safety googles and gloves
when handling polluted filters or pre-filters.
- Do not use the equipment without the fi lters.
- Saturated filters can not be cleaned and reused.
- Avoid blowing out the fi lter or the dirty parts of the equipment, if necessary it is recommendable to
vacuum them.
- When handling the fi lter, avoid losing particles from the fi lter.
- Treat the saturated filters as waste depending on the filtered contaminant and the applicable standards
in each country. This is the European Waste Catalog classification:
15 02:
Absorbents, filter materials, wiping cloths and protective clothing.
15 02 02:
Absorbents, filter materials (including oil filters not otherwise specified), wiping cloths,
protective clothing contaminated by dangerous substances.
15 02 03:
Absorbents, filter materials, wiping cloths and protective clothing other than those mentioned
in 15 02 02.
- In case of not complying with the filter change recommendations, the maximum particle and gas
concentrations established in each country could be exceeded.
Follow safety guidelines to prevent electric shock, injury, fire or explosion.
16
