3
Desoldering process
Use the tip model with a larger diameter than the
pad to be desoldered, so as to achieve maximum
aspiration and thermal efficiency.
1.
Apply the desoldering iron tip so that the
component terminal penetrates within its orifice.
2.
When the solder liquefies, start gently to rotate
the desoldering tip so that the compo nent’s terminal
can be eased away from the sides.
3.
Press then, not before, the vacuum pump
push-button just long enough to aspirate the solder.
Control Unit
DR-SD
Desoldering Stand
DR560-A
Desoldering Iron
MS-A
Desoldering Pump
Connectable control units:
DI, DD, DM
and
RM
.
Mains
Equipotential connection
After pressing the desoldering key there is a slight
delay until the self-contained vacuum pump stops,
this is to make sure that the vacuum circuit is
completely empty.
If any solder remains are left on any terminal after
attempting to desolder it, resolder it with fresh solder
and repeat the desoldering operation.
Features
www.jbctools.com
1
2
3