3
1
4
2
6. Cartridge Insertion and Charging
Place the tool over a cartridge
and press the tool down to insert
the cartridge (1). To release the
tool with the cartridge from the
extractor, lift the tool upward (2).
Make sure that the cartridge is
appropriately inserted* into the
tool by gently pressing the tip
against the holes on the sides
of the cartridge exchanger (3).
*Important:
Cartridges must
be inserted up to the mark for
a proper connection.
Place the tool on the tool charger
(4) to charge it. A beep will sound
to confi rm that the tool is properly
placed and charging.
The sound can be turned up,
down or off using the buttons on
the display.
Note:
Charge the tool
completely before using it for
the first time. It will take aprox.:
-30 min for B·IRON 100 TOOL
-60 min for B·IRON 500 TOOL
-30 min for B·NANO TOOL
-40 min for B·TWEEZERS TOOL
For more information on how to change cartridges and the use of the cartridge exchanger, see section
“Cartridge Exchanger and Cartridge Holder”.
Inserting
Fixing
Charging
Mark
1
2
5
Retention
Clamps
Cartridge Exchanger
Cartridges are held in place inside the cartridge
exchanger thanks to the retention clamps (5),
with the advantage that the cartridges do not
fall into the exchanger and the cartridge tips are
therefore protected.
The cartridge exchanger of B·IRON stations
works with C210 and C115 cartridges.
Cartridge Retention
The cartridge exchanger saves time and allows to change cartridges safely without switching the
tool off.
Place the cartridge over one of the slots of the
cartridge exchanger and press down (1) until
you hear a click. Then pull the handle out (2)
to remove the cartridge.
1. Removing Cartridges
Cartridge
Exchanger
C115
Cartridge
Place the handle over a cartridge and press the
handle down to insert the cartridge.
2. Inserting Cartridges
C115 Cartridge Retention Area
The holding area of C115 cartridges is delimited
by the two rings at the cartridge shaft (x).
C210 Cartridge Retention Area
The holding area of C210 cartridges goes from
the collar of the tip until the cartridge begins
to widen (x).
C210
Cartridge
x
x
1
2
5
Retention
Clamps
Cartridge Exchanger
Cartridges are held in place inside the cartridge
exchanger thanks to the retention clamps (5),
with the advantage that the cartridges do not
fall into the exchanger and the cartridge tips are
therefore protected.
The cartridge exchanger of B·IRON stations
works with C210 and C115 cartridges.
Cartridge Retention
The cartridge exchanger saves time and allows to change cartridges safely without switching the
tool off.
Place the cartridge over one of the slots of the
cartridge exchanger and press down (1) until
you hear a click. Then pull the handle out (2)
to remove the cartridge.
1. Removing Cartridges
Cartridge
Exchanger
C115
Cartridge
Place the handle over a cartridge and press the
handle down to insert the cartridge.
2. Inserting Cartridges
C115 Cartridge Retention Area
The holding area of C115 cartridges is delimited
by the two rings at the cartridge shaft (x).
C210 Cartridge Retention Area
The holding area of C210 cartridges goes from
the collar of the tip until the cartridge begins
to widen (x).
C210
Cartridge
x
x
4
Cartridge Insertion and Charging
