ENGLISH
USER MANUAL
JB Systems
®
9/12
ACCU DECOLITE IP
o
Status LED (17) BLUE : unit is in TRANSMITTER mode and connected to one or more receivers.
o
Status LED (17) BLUE (blinking fast) : unit (transmitter) is connecting to receiver(s).
o
Status LED (17) BLUE (blinking slow) : no DMX-signal present on transmitter
o
Status LED (17) GREEN : unit is connected to a transmitter
o
Status LED (17) GREEN (blinking slow) : unit receives no DMX-signal from transmitter.
•
A receiver can only connect to a transmitter while it is completely disconnected: status led (17) is WHITE.
SETTING UP IN TRANSMITTER MODE (LED = BLUE)
•
Keep the [ID] button (7) pressed while powering up the WIRELESS part of the ACCU DECOLITE IP by
pressing the according button (2). The status LED will become WHITE shortly, than turns BLUE, RED or
GREEN (the last selected mode).
•
Choose BLUE by pressing the [ID] button (7) shortly.
•
Once BLUE selected, press the [ID] button (7) for 3 seconds to confirm the transmitter mode.
•
The status LED will turn white and after a few seconds turns BLUE (blinking if there is no DMX signal
present)
•
The unit is now in transmitter mode.
SETTING UP IN RECEIVER MODE (LED = GREEN)
•
Keep the [ID] button (7) pressed while powering up the WIRELESS part of the ACCU DECOLITE IP by
pressing the according button (2). The status LED will become WHITE shortly, than turns BLUE, RED or
GREEN (the last selected mode).
•
Choose GREEN by pressing the [ID] button (7) shortly.
•
Once GREEN selected, press the [ID] button (7) for 3 seconds to confirm the receiver mode.
•
The status LED will turn white and after a few seconds turns RED (fast blinking if there is no signal present)
or GREEN (when the receiver is paired with a transmitter).
•
The unit is now in receiver mode.
•
Release the receiver from any universe (transmitter) by pressing the [ID] button (7) for 5 seconds. The
status led now turns WHITE. The unit is now ready to be paired with a transmitter.
PAIRING TRANSMITTER AND RECEIVER(S)
•
First of all : prepare transmitter and receiver(s) as described above.
•
Press the [ID] button (7) on the transmitter. The BLUE led starts blinking and the led on the receiver(s)
starts blinking GREEN at the same time.
After a few seconds the leds stop blinking. The transmitter and receiver(s) are now paired.
DISCONNECTING RECEIVERS FROM A DMX UNIVERSE (TRANSMITTER)
To disconnect all the receivers from a DMX universe / transmitter:
•
Press the [ID] button (7) from the transmitter for about 5 seconds until the status LED (17) turns RED, the
status LED on the receiver(s) turn WHITE (disconnected).
•
After a few moments the status LED (17) on the transmitter turns BLUE again.
•
You can also re-connect the receiver(s) again simply by pressing shortly on the [ID] button (7) on the
transmitter. (The status LED (17) on the receiver(s) turns GREEN again.
To disconnect an individual receiver from a DMX universe / transmitter:
•
Press the [ID] button (7) of the receiver until the status LED (17) becomes WHITE (RGB lit).
•
This receiver is now disconnected from the transmitter (DMX universe).
