ENGLISH
USER MANUAL
JB Systems
®
8/12
ACCU DECOLITE IP
[SoUA] Sound Mode
Used to make shows working on sound or not.
•
Press the [
■] button.
•
Press the
▲ or ▼ buttons until the display shows
[SoUA]
.
•
Press [
] button to select. The display starts blinking.
•
Press [
], the projector is now working in sound mode.
If you want to go back to normal running mode: press the [
■] button.
[Led] Mode
Led of10-30-60-90 : display turns off after 10-30-60 or 90 seconds.
•
Press the [
■] button.
•
Press the
▲ or ▼ buttons until the display shows
[LEd]
.
•
Press [
] button to select. The display starts blinking and shows [oF10-oF30-oF60 or oF90]
•
Select the desired setting by pressing the
▲ or ▼ button.
•
Press [
] to select the desired mode.
•
The display will turn off after .
•
The display will turn on again by pressing one of the buttons [
■], [▲], [▼], [ID] or [
]
[node] Function
Used to slow down the dimming speed.
•
Press the [
■] button.
•
Press the
▲ or ▼ buttons until the display shows
[node]
.
•
Press the [
] button. The display starts blinking and shows [
nod0…nod4]
•
Use
▲ and ▼ buttons to select
[
nod0…nod4]
where 0 is the fastest and 4 the slowest mode.
•
Once the desired mode is selected, press the
[
]
button to confirm.
[UErn] Software Version
Used to show the software version of the unit.
•
Press the [
■] button.
•
Press the
▲ or ▼ buttons until the display shows
[UErn]
.
•
Press the [
] button. The display starts blinking and shows the version
[UE2.0]
.
•
Press the [
■] button to leave.
[LoC] Lock/unlock
Used to lock and unlock the display functionality.
•
Press the [■] button.
•
Press the ▲ or ▼ buttons until the display shows
[LoC]
.
•
Press the [
] button. The display starts blinking and shows
[oFF]
.
•
Press the ▲ or ▼ buttons to change to
[on]
.
•
Press the [
] button. The display functions are locked now.
•
Press the [
] button and ▼button simultaneously to unlock the display functions.
•
Press the [■] button to leave.
[SETUP FOR WIRELESS OPERATION]
Each unit has a wireless DMX transceiver on board. This means that every unit can be transmitter or
receiver.
To set up the system, you first need to assign each receiver to the universe (transmitter) it should work with.
Each unit has a wireless DMX transceiver on board. This means that every unit can be transmitter or
receiver.
To set up the system, you first need to assign each receiver to the universe (transmitter) it should work with.
VERY IMPORTANT THINGS TO KNOW BEFORE USE
Before you start using these wireless DMX units, you should know about the following some basic
information. It will save you a lot of time and frustration:
•
Check information on the [ID] button (24) and status led (16).
o
Status LED (17) WHITE : unit is in setup mode or disconnected from any transmitter.