Rev-A
Page
5
of
6
ASSEMBLY INSTRUCTIONS
1)
Affix two rubber strips to each wall rack cradle. These will help to protect the
finish on your standards.
2)
The wall rack should be securely anchored to the wall using a suitable anchor
chosen for the type of wall being mounted to, whether CMU block, poured
concrete or studded. If attaching to a studded wall ensure that the anchors are
attached directly to the studs. See page 4 of 5 for additional information.
3)
Locate the general area where the wall rack (1) is to be mounted. Drill three
appropriately sized pilot holes approximately 4 ½’ (54”) above floor level and at
16” / 8” on center from each other.
4 ½’ (54”) Off Floor
Center of Bracket
