Rev: E
Page
5
of
8
Figure 4
Install Poles:
Before inserting the poles into the sleeves, check to make sure:
1.
The cleat installed opposite of pulley.
2.
Run the hoisting rope thru pulley
a.
Secure both ends together (loosely).
3.
Note orientation (see Figure 5).
Figure 5
1/4"-20 x 5 1/2" HEX HD SCREW
(3X) CORD LOOP ASSEMBLY
5/16” x 3 1/8” SNAP HOOK
1/4"-20 NYLON LOCK NUT
1/4" FLAT WASHER
6" LONG CLEAT
~ BACK SIDE ~
POLE
3/8"-16 THIN NYLON LOCK NUT
3/8" FLAT WASHER
3/8”-16 x 1” CARRIAGE BOLT, ZP
4” ID BAND CLAMP, GALVANIZED
5/16” x 3 1/8” SNAP HOOK
(3/8” bolt must pass thru small end)
NOTE: SLIDE BANK CLAMP FROM BOTTOM OF POLE FOR EASE OF INSTALLATION.
DO NOT OVER TIGHTEN BAND CLAMP
Net length divided by spacing = pole distance
Intermediate Pole
End Pole
Cleat
Pulley
Net
Slide the cord loops onto the poles and place them just above the cleat so they will be
held in place while installing the poles.
