![background image](http://html1.mh-extra.com/html/jayco/seneca/seneca_owners-manual_3687440073.webp)
SECTION 8
SLIDEOUT SYSTEMS
2. Disconnect one slideout motor wire near
the motor.
3. The slideout is now free to move. Locate
the access panel either at the front or rear
of the slideout rail. Remove the access
panel for the manual slideout shaft.
4. Use a 3/4 socket and ratchet on the hex
head located on either end of the drive
shaft and turn the shaft until the slideout is
in the position you desire.
When the slideout is fully extended (or
retracted), put pressure on the wrench to
ensure a tight seal, then return the brake
release lever to its normal downward
position. This will ensure that the slideout
is locked into a sealed position.
When the slideout motor brake is released,
the slideout will not lock into place, and
therefore it will not be sealed from the
outdoors! When the slideout has been
retracted, return the brake release lever to
its downward position in order to seal and
lock the slideout.
8 - 3
Summary of Contents for SENECA
