![background image](http://html1.mh-extra.com/html/jayco/melbourne-2011/melbourne-2011_owners-manual_636023083.webp)
SECTION 11
CAMPING & OPERATING
seat belts out into their usable positions).
Refer to the furniture manufacturer’s care
instructions for this product.
Electric sofa
To recline the sofa, push and hold the 12-volt
sofa control switch until the sofa back and
seat cushion are in the bed position. Reverse
this process to convert the sofa back to the
travel position.
Q
UEEN
B
ED
(I
F
S
O
E
QUIPPED
)
There is a limited storage area located under
the queen bed. To access, grasp the end
ledge at the foot of the bed and lift carefully.
Use the gas struts to help you hold the bed
temporarily in the upright position. Before
lifting, be sure there is nothing on the bed that
will restrict its movement or add extra weight.
Use caution when opening or closing the bed
to keep hands and fingers at the end ledge
provided (not on the side or further back than
necessary) to avoid pinch points. When
lowering the bed, be sure to keep both hands
on the end ledge while slowly lowering it to
the closed position. Avoid letting the bed
suddenly drop shut.
The bedroom electric slide room system may
be located under the queen bed. If so, it can
be accessed by removing the screws holding
the wooden paneling in place. Use care not to
obstruct the slide room system when using
the under bed storage area.
P
RIVACY
D
RAPE
I
NSTALLATION
Remove the privacy drape from the storage
bag, which you should find in the storage area
under the mattress platform in the bedroom.
1. Starting at the driver's side of the cab,
attach the black plastic hook to the loop
attached to the wall behind the driver's
seat. Make sure that the side of the drape
with Velcro® is facing the motorhome
windshield.
2. Pull the drape toward the front of the RV
and behind the driver's side sun visor.
Open the sun visor against the windshield
to hold the drape in place.
3. Proceed across the windshield to the
passenger side, again placing the drape
behind the sun visor and opening the sun
visor to hold the drape in place.
4. Attach the black plastic hook at the
passenger's side of the cab to the loop
attached to the wall behind the
passenger's seat.
5. Attach the Velcro® at the top edge of the
drape above the driver's and passenger's
doors to the corresponding Velcro on the
roof of the motorhome cab.
6. The Velcro® at the bottom corners of the
privacy drape under the black plastic
hooks should also be attached to the
Velcro on the walls of the motorhome in
the corresponding locations.
Make sure to remove your privacy drape and
place it in storage before traveling.
TV
P
OWER
S
UPPLY
For good station reception, the
TV power supply must be turned
ON to view local television
stations. Turning the TV power
supply ON sends 12-volt DC
through the cable to the TV roof
antenna. The voltage energizes
the transistors in the antenna
head amplifier. The TV signal
then comes down the cable to
the outlets.
Fig. 11.2 TV
Power Supply
Turn the TV power supply OFF to view cable
television or to use a VCR or DVD.
TV
A
NTENNA
&
C
ABLE
TV
RG-6 coax runs from the TV antenna and
exterior cable TV connector to a wall plate
near the dedicated television space.
The television entertainment system will not
run cable television on one television set and
local stations off the other set without
customer modification. You can either view
local stations or you can view cable television.
79
Summary of Contents for Melbourne 2011
