![background image](http://html1.mh-extra.com/html/jayco/jay-flight-bungalow-2010/jay-flight-bungalow-2010_owners-manual_3625428070.webp)
SECTION 9
SLIDEOUT SYSTEMS
66
If the slideout extends crooked or only one
side moves, follow these steps.
the side of the seal to avoid the possibility of
water penetration.
Follow steps on overriding the specific
slideout system installed on your park
trailer.
Retracting slideout room
Press the IN section of the slideout control
switch and hold it until the motor stops.
Operating the switch after the room is fully
retracted will damage the switch and motor.
You may need to push the side that is not
sliding to get it to retract all the way.
Maintenance
Contact your dealer or Jayco Customer
Service for repair assistance.
Your slideout system has been designed to
require very little maintenance. To ensure a
long life of your slideout system, read,
understand and follow these simple
instructions. This system contains a pre-lubed
bearing that is lubricated when the room is
moved in and out. Do not spray oil or grease
on the rails while the room is extended.
T
ROUBLESHOOTING
T
HE
S
LIDEOUT
If the slideout does not move when the
slideout switch is depressed, follow these
steps.
Check the auxiliary battery (customer
supplied) for a full charge and good wire
connections.
Check the 12-volt fuse or circuit breaker.
Check for loose connections at the
slideout motor.
If the slideout still will not operate, follow
these steps.
If the slideout is extended, refer to the
following section on overriding the specific
slideout system installed on your park
trailer.
If the slideout is retracted, leave it in that
position.
Contact your dealer or Jayco Customer
Service for repair assistance.
Dexter Chassis Group (V-tech) slideout
override
Do not work on your system unless the 12-
volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical
systems (shore line power cord) have been
disconnected.
If the park trailer has an
underbelly, locate and
remove the access
panel to access the
slideout motor (this
panel is typically under
the park trailer on the
opposite side of the
slideout room). Use a ¾
socket and ratchet on
the hex head located on the end of the drive
shaft. Turn the drive shaft until the slideout is
in the position you desire. Contact your
dealer for service.
Fig. 9.4 V-tech
slide hex head
Summary of Contents for JAY FLIGHT BUNGALOW 2010
