![background image](http://html1.mh-extra.com/html/jayco/eagle-fw-ht-2020/eagle-fw-ht-2020_owners-manual_636005085.webp)
Section 5: Slideout Systems
83
Refer to the Power Gear® website
for additional information.
Override Modes:
In the event of component failure or loss of system power, your slideout can be manually
overridden and retracted for travel.
Emergency Retract Mode
Use this procedure when there is
NO
loss of power or electrical problem with the system.
1.
Remove the touchpad (Fig 4) from the wall.
2.
Prior to clearing the MAJOR fault, record the number of
RED & GREEN flashes observed on the touchpad (Fig 6).
This information will help your dealer/service center in
troubleshooting the slideout system.
3.
Press and hold the SET STOPS/CLEAR FAULTS button
on the back of the touchpad for five (5) seconds (Fig 2). Both RED & GREEN LEDs
will be on solid while pressing this button. After 5 seconds, the GREEN LED will
begin flashing and the RED LED will remain solid on.
4.
The unit is now ready to retract the room. Press and hold the ROOM SLIDEOUT MO-
TOR buttons 1 and 2 on the back of the touchpad (Fig 3).
Press the IN button on the front of the wall touchpad until the room is fully retracted. If one
side of the room needs to retract further in order to get a good seal, press and hold the motor
button (Fig 3) corresponding to ONLY the motor you want to move. Press the IN button on
the front of the touchpad to retract the room the remainder of the way.
It is very important to note that during this procedure, the slideout control
has NO stop locations. Use a second person to assist in determining when
the room is retracted. Damage to the room can occur if the room is retracted
too far.
NOTE:
During the override procedure, the unit will exit this mode
if the room has not been moved for two (2) minutes or if a fault is
detected during room movement. The Fault Code (RED) and Room
or Lock Movement (GREEN) LEDs will flash rapidly for 10 seconds to
indicate the override procedure failed. After 10 seconds of flashing,
the control will automatically default to FAULT CODE 1. Program
-
ming must be restarted.
NOTE:
After overriding the system, the room control will need to be
re-programmed by an OEM authorized dealer.
Summary of Contents for EAGLE FW HT 2020
