Jayco Designer 27 RKS, Owner'S Manual

Page: 84 / 115

73
If ignition does not occur after two or three times, check the LP gas supply line; consult
your local dealer or an authorized Norcold Serivice Center; change to manual mode and
operate on AC electric, or DC electric (3-way models only).
Ice Maker
Ice maker is assembled to the refrigerators at the factory as optional equipment. If the
refrigerator does not have a factory installed ice maker, one can not be added to the
refrigerator at a later time.
ICE MAKER OPERATION
1. Open the water shut off valve of the vehicle.
NOTE: Make sure that the ice maker arm can move freely and does not touch the
frozen foods in the freezer
2. Push the ice maker arm down to the ON position.
CAUTION: If you operate the refrigerator without connecting the water supply line
and/or opening the water shut off valve of the vehicle, make sure the ice maker arm
is up in the OFF position.
3. Allow the freezer to cool to 32° F (0° C) (a minimum of 24 hours) and ice
production will begin to fill the storage bin.
NOTE: New plumbing connections and/or impurities in the water supply line after
winterizing can cause the first ice to be discolored or have an odd flavor.
4. To stop the ice maker, push the ice maker arm up to the OFF position.
REFRIGERATOR - RESIDENTIAL UNITS
Refer to the owner’s manual supplied with your unit.
CAUTION: Ensure travel strap is in place prior to travel.
MONITOR PANEL
The monitor panel will provide useful information on the capacities of the water tanks
and the battery condition. In fifth wheel travel trailers and conventional travel trailers you
will find a wall mounted panel as shown. Follow instructions below regarding operation.
The panel operates on 12-volt DC power supplied by the converter or battery. Sensors are
installed into the tanks and a resistor assembly relaying a message through wires to the
display board on the panel. No power is drawn from the battery unless a switch is pushed
or turned on.