Jayco 2016 White Hawk, Owner'S Manual

Page: 98 / 150

SECTION 7 – PLUMBING SYSTEM JAYCO TOWABLE
TABLE OF CONTENTS
8-4
The water pump switch should be in the OFF position when the RV is left unattended
for any amount of time. If something would happen to the water system, this may
help limit water damage to a smaller area.
Water pump
W
ATER
P
RESSURE
R
EGULATOR
(
CUSTOMER
S
UPPLIED
)
Excessive pressure from the water supply source may be encountered in some parks,
especially in mountain regions when using the fresh water inlet or black tank flush. Water
pressure regulators are available to protect your recreation vehicles plumbing system
against such high pressure.
Fresh Water Connections
Your recreation vehicle may be equipped with one or both of the following fresh water
connections: city water and gravity fill. The city water fill has a threaded connector with a
city water connection label next to it. Do not remove this label.
Using City Water Fill (If So Equipped)

NOTE : If needed, sanitize the water system prior
to travel.
1. Remove the connection cap and attach a non-
toxic drinking water hose to the threaded inlet.
The other end of this hose should be connected to
a pressurized fresh water source (such as a faucet
or spigot).
You should use a non-toxic drinking water hose
dedicated only to supplying fresh water to the
vehicle. To reduce the chance of contamination,
prevent the non-toxic drinking water hose from
coming into contact with the ground.
Water pump strainer
CAUTION
A water pressure regulator is recommended to prevent damage to the plumbing
system or components. To prevent damage when using the city water connection, a
45 lb. (315 KPa) rated water pressure regulator is recommended.
City Water Fill with City
Water Connection label