43
v
ehicle
o
peration
K
eys
Several keys are provided when you purchase your vehicle. Most keys have an individual
key number stamped on the plate. Record these key numbers and keep the information in a
safe place. You can order a key blank from your dealer to have duplicate keys made. If you
lose the keys, contact your dealer or a locksmith for assistance.
Make sure the keys are
not inside the vehicle before you close and lock the entrance door.
K
eyless Entry (if so equipped)
If your RV is equipped with a keyless entry system, it is a battery operated system.
Programming and changing batteries on the lock system are described in the following
sections.
For detailed instructions, please refer to the manufacturer’s operators manual included in
your warranty packet.
Battery powered keyless entry system:
The battery powered entry system is a 4 button touch pad programmable deadbolt lock. The
4 buttons are labeled “1|2”, “3|4”, “5|6”, “7|8”. The button labeled “1|2” is the same button
whether the number 1 or 2 is desired. Please note this handle uses touch technology. The
buttons are activated by touch and do not require pressing the buttons. Touch the button and
lift finger from button for proper code entry.
Operation
The entry system incorporates proximity sensing to determine when you want to activate
the lock. To operate the lock you first must “wake up” the lock, by touching the “wake up
area” to the right of the buttons. The buttons will illuminate once the Touch Pad is wakened.
This indicates that the touch pad is ready for the code to be entered. (Refer to the diagram
on next page)
Preset Factory Code
The entry system has a factory set code of 3,7,1,5 followed by the Enter button. The Enter
button is the bottom button with the picture of the key. The Enter button is required to
be touched after the code is entered. The factory code resets every time the batteries are
removed for at least 10 seconds.
Programming New Code
To set a new code, wake up the lock by touching the “wake up area”. Then touch and hold
both the “3|4” button and the Enter Button for 2 seconds. The system will provide three short
beeps, indicating it is ready to accept a new code. Enter the new 4 digit code followed by
the Enter button. The system will provide four short beeps to indicate new code acceptance.
This new code will now activate the lock.
To reset the code, remove the batteries for at least 10 seconds. Re-install the batteries; and
follow the steps to
Programming New Code.
NOTE:
Locks on entrance and baggage doors need biannual lubri-
cation using a light coat of silicone spray. Conditions such as rain,
salt, dust and pollution may increase the maintenance needs.
Summary of Contents for 2016 PINNACLE
