Jayco 2016 PINNACLE, User Manual

Page: 133 / 167

123
h
eating
& c
ooling
To ensure your personal safety, do not obstruct or alter the furnace in any
manner. Do not install screens over the vent for any reason. Screens will
become restricted and cause unsafe furnace operation. For your safety, only
the manufacturer’s factory authorized parts should be used on your furnace.

F ireplace (If So Equipped)
The controls are located on the upper right of the fireplace.
(Switch “A”: This is a 3 position rocker switch.
Center Position is OFF
Position “I” is for Manual Operation. If selected, the
built-in remote control is bypassed.
Position “II” is for operating the unit with the provided
remote control. When in the “II” position, the unit is
operated with the ON/OFF buttons on the remote control.
(See Remote Operation section)
Switch “B” Heater ON/OFF:
The Heater ON/OFF switch supplies power to the heater fan and
the heater element. When the switch is ON, the heater will
operate if the thermostat calls for heat.
Switch “C” Heater Thermostat Control:
To adjust the temperature to your individual requirements, turn the thermostat control
Controls
Remote
NOTE:
The fan will continue running even when the heater is not,
when the Heater Switch is in the ON position.
NOTE:
The heater may emit a slight, harmless odor when first
used. This odor is a normal condition caused by the initial heating of
internal heater parts will not occur again.