Jayco 2016 North Point, User Manual

Page: 48 / 147

JAYCO TOWABLE SECTION 4-TOWING & SET-UP
General Maintenance and Operating Guidelines

Install fresh batteries as necessary. The lock is designed to function for months of
normal usage with fresh, high quality AA batteries. Battery life is highly dependent
upon battery quality, usage, and environment (temperature).

Make sure there are no obstructions in the door frame to prevent Dead Bolt extension.

Do not wash with power washer or high pressure cleaner. The lock is designed to
resist water intrusion to protect its electrical components from normal water
encounter such as rain.

The lock uses Touch Technology. The buttons are activated by touching not pressing.

Remove batteries when storing or not using this lock for extended periods of time.
(
Note: the factory code will reset when the batteries are removed for longer than 10
seconds)
Rain Sensing Technology:
The lock system has Rain Sensing Technology to preserve battery life. Rain will wake up
the touch pad and illuminate the buttons. After a few seconds of contact from rain (water)
the lights turn off, but a code can be entered and the lock will function normally. The
same effect occurs if the operator touches a button for a prolonged period of time. The
buttons will illuminate, but then turn off. Again the lock will function normally.
Additional Security Feature:
The lock system recognizes the first 4 digits entered as the code. However if you feel
someone is watching you enter the code you can continue to enter digits after the first 4
prior to touching the enter button. For example, if your code is 8,1,3,9 and you felt like
you were being watched you would enter 8,1,3,9 then continue to touch additional digits
before touching the enter button and the lock will still operate.
Trouble shooting
After installation the touch pad does not work

Batteries are dead

Batteries are not installed properly

Plug not engaged properly

Dead Bolt not engaging into Door Frame

Obstruction in Door Frame

Code not working

Remove Batteries for 10 seconds then Program New Code

Inside Paddle not Opening Latch

Inside screws are not secured to the Housing.

Buttons light but the Dead Bolt does not activate

Replace the batteries
If the problem is not found on this list, please refer to the manufacturer’s operators manual.
Battery Installation:
The entry system uses 4 AA batteries for operation. We do not recommend zinc carbon
batteries for this application
Fresh batteries should be installed as necessary. Battery Life is highly dependent upon
battery quality, usage, and environment (temperature). Remove batteries if the lock will
not be used for extended periods of time.
The following steps are shown on the enclosed Battery Installation schematic.
1. Remove (2) 4x40 screws from Battery Compartment Lid. These screws are very
small so please take care in removal and installation.
4-6