Jayco 2013 JAY FEATHER TOWABLES, Owner'S Manual

Page: 57 / 134

JAYCO TOWABLE SECTION 4 - TOWING & SET-UP
4-11
2. Enter the 5 digit authority code assigned in process “A” above. Once input
the keypad will emit a long beep.
3. You can define up to 5 different keypad access codes. The next button
pressed and released determines which access code you are programming. If
you press and release button #1 you are indicating that you want to program
access code #1. If you press and release button #2 you are indicating that
you want to program access code #2. This process also applies to access
codes #3, #4, and #5. The keypad will emit a single confirmation beep after
this single button press.
4. Enter a unique 5 digit access code into the keypad. The keypad will beep
twice to confirm each button press.
5. Re-enter the same unique 5 digit access code into the keypad. The keypad
will beep 3 times to confirm successful programming. A long beep indicates
programming failure.
6. Record the new 5 digit access code in a safe place for future reference.
7. Repeat the 6 steps above to program additional access codes.
For detailed instructions refer to the manufacturer’s user guide included in the
Warranty Packet.
Battery powered keyless entry system: Revision 12/05/12
The battery powered entry system is a 4 touch pad button programmable deadbolt
lock. The 4 buttons are labeled “1|2”, “3|4”, “5|6”, “7|8”. The button labeled “1|2” is
the same button whether the number 1 or 2 is desired. Please note this handle
uses touch technology. The buttons are activated by touch and does not require
pressing the buttons. Touch the button and lift finger from button for proper code
entry.
Operation
The entry system incorporates proximity sensing to determine when you want to
activate the lock. To operate the lock you first must “wake up” the lock. To “wake
up” the lock you must touch the area next to the buttons. The buttons will
illuminate once the Touch Pad is wakened. This indicates that the touch pad is
ready for the code to be entered.
Preset Factory Code
The entry system has a factory set code of 3,7,1,5 followed by the Enter button.
The Enter button is required to be touched after the code is entered. The factory
code resets every time the batteries are removed for at least 10 seconds.
Programming New Code
To set a new code, touch and hold the “3|4” button and the Enter Buttons for 2
seconds. The system will provide three short beeps, indicating it is ready to accept
a new code. Enter the new 4 digit code followed by the “*”. The system will provide
four short beeps to indicate new code acceptance. This new code will now activate
the lock.
To reset the code, remove the batteries for at least 10 seconds. Re-install the
batteries; and follow the steps to
Programming New Code .
Please Enter Personal Code upon Installation of Lock to prevent inadvertent
programming.
System Fault Logic:
Action
Response
Ready to Accept New Code Three short beeps