Addr (DMX Mode), press ENTER to choose this function, this is for unit to work under DMX mode; the small
round dots near A flashes stands for there is DMX signal input, if no flashes, means no DMX signal input;
Master-slave settings:
Work Without DMX : Please connect all the units with DMX Signal cables, choose one unit as Master, and run the
above modes except Addr, set all other units to be Slave by set their Addr as any DMX address;
Work with DMX : Please connect all the units with DMX Signal cables, choose one unit as Master, and connect it to
the DMX controller, and choose the mode of Addr, set its Addr to be any DMX address, and set all other Slave
units by set their Addr to be the same DMX address as Master unit.
DMX Mode: Operating through a DMX controller give the user the freedom to create their own programs tailored to
their own individual needs. This function also allows you to use your units as spot lights.
1. This function will allow you to control each individual unit’s traits with a standard DMX 512 controller.
2.
The High Power LED Par 64 light uses 6 DMX channels to operate. Please refer to 6CH DMX values and
functions chart as below:
3. To run your unit in DMX mode, plug in the unit via the XLR connections to any standard DMX controller. Set
your desired DMX address following the setup specifications that come with your DMX controller.
4.
Note: When in Master/Slave Synchronization Mode, only one unit in a series chain can be set as the master.
5.
6CH DMX Values and Functions:
Channel
Value
Function
1
DIMMER
0 - 9
No function
10-255
dimmer 0-100%
2
STROBE
0 - 10
No function
11-255
STROBE 0-100%
3 RED
0~1
No function
2-255
RED
，
brightness 0-100%
4
GREE
N
0~1
No function
2-255
Green
，
brightness 0-100%
5
BLUE
0~1
No function
2-255
Blue
，
brightness 0-100%
6
RGB
MIXING
0-10
RGB off
11~30
B on
31~50
G on
51~70
B + G on
71~90
R on
91~110
R + B on
111~130
R +G on
131~255
R +G +B on
3
/
4
