On the top of LCD screen is the TARGET ID
，
namely target identification
cursor. On the bottom is the DEPTH-SENS, namely the depth and sensitivity shared
cursor. The central left is the low-voltage indication cursor.
When searching,the target identification cursor divide the metal targets into
three categories :
Silver Higher conductivity metals,such as silver, aluminum and copper.
MID RANGE——Medium conductivity metals, such as nickel and some coins.
Generally golden rings can be also illumined at this point.
IRON——Low conductivity metals, such as iron and all types of ferrous metals
can be illumined at this point.
When presetting the Target Identification button to discriminate mode,it
indicates as the discrimination mode.
When turning on the unit,the DEPTH-SENS instructs the sensitivity cursor,
turn to the initial state, the three segments of the left is lighted,it means the
sensitivity is in the third level. Press the "SENSTIVITY" "+" key,the detector
sounds four tones,the four segments of the DEPTH-SENS are all lighted, it
means the sensitivity is in the fourth level,that is the most advanced level.
Press the "SENSTIVITY" "-" keys,the tones of the detector are reduced one
time,and the segments of lighted are also reduced one section, it means the
sensitivity is reduces a level.
When searching,the DEPTH-SENS directs the target depth. The first
segment that is also the "0" segment illuminated and flickered,it indicates the
metal target is near the ground. The fourth segment that is the "6" segment
illuminated and flickered, it indicates the target is at about the 6 inches
position. Of course, It only shows the relative depth of the metal objects,
rather than the precise depth.
When it find the targets, The TARGET ID and DEPTH ID will flicker about 5
seconds, and then the cursor of the discriminate mode and the sensitivity
instruction will come back to the pre-set position,and will remain unchanged
until find the metal targets next time.
The low battery indication cursor
When the cursor
on the left of the LCD is lighted,which indicates you it’s the
time to change the battery.
2
，
Three kinds of sounds
Press the “POWER ON” button, the detector will sound the three frequencies of
“low,medium,high” tones,the sensitivity ruler mark illumines three segments,which
means the sensitivity is in the third level. The Target Indication cursor isn’t
illuminated, which means the discrimination mode is set in the ALL METAL state.
When sweeping the four types of metals 2 inches above the top of search coil,the
detector will respond with different sound.,the target identification on LCD will be
illumined correspondingly.
5
