3.
Set Speed Dome Address and Baud Rate. At the back of speed dome attached the dial-up switches
description, shown in figure 2.3. At the profile there are SW1 and SW2, shown in figure 2.4, used for
setting the address, baud rate, communication protocol. Please refer to section 2.4, “Switches Settings”, for
details.
Figure 2.3 Dial-up switches description
O
N
1 2 3 4 5 6 7 8
O
N
1 2 3 4 5 6 7 8
SW1
SW2
on
on
Figure 2.4 Dial-up switches on the profile of the camera.
4.
Install the dome cover. Open the joint interface on the cover, pull the wire twisted in the bracket into the
dome cover through the interface (Note: don’t plug in the supply power, or else wire whip may happen).
Rotate the cover onto the brackets, and lock the locking screw on the bracket, shown in figure 2.5. Fix the
cover, then install the sockets, fix the joint interface.
Note: When install a Speed dome outdoor, please wind the interface between the cover and bracket with
Teflon Tape to avoid water entering into the dome.
6
