JAY
®
FIT 2U
®
Back
255813 Rev. A
4
III. INTRODUCTION
Sunrise Medical recommends that a clinician such as a doctor or
therapist experienced in seating and positioning be consulted to
determine if a JAY FIT 2U Back is appropriate. Backs should only be
set up by a Sunrise Medical authorized dealer.
JAY FIT 2U
The JAY FIT 2U Back is designed to provide the important benefi ts of a
proper back support for a wide variety of users.
Maximum user weight:
- 165 lbs (75 kg) for widths 14-in and below
- 300 lbs (136 kg) for widths 16-in and above
A. Fitting the back to the Wheelchair
WARNING
The owner of this equipment is responsible for ensuring that it has been set
up and adjusted by a Sunrise Medical authorized dealer under the advice
of a health care provider. The back and hardware may require periodic
safety and function checks. Adjustments should be performed by your
Sunrise Medical authorized dealer. Always use parts and/or accessories
that have been recommended or approved by Sunrise Medical.
The JAY FIT 2U Back is designed to be compatible with most
wheelchairs with the following exception: Wheelchairs that are angle
adjustable with recline or tilt that result in a back angle greater than 60°
from the vertical should not be used with the JAY FIT 2U back system.
B. Wheelchair Dimensions
Prior to placement, determine if the wheelchair used has compatible
back canes by measuring the width between the back canes (as shown
in Fig 3). The JAY FIT 2U Back off ers up to 2-in (5 cm) of back cane
width adjustment.
Next, check that the back canes are a compatible diameter. The JAY
FIT 2U back hardware can be mounted on wheelchair back canes
ranging from 3/4-in to 1 1/8-in (1.9 cm to 2.86 cm) . Measure your
back cane diameter (Fig 4) and refer to Table 2 to ensure your back
canes are compatible. If you cannot determine that the back canes are
compatible, please contact your Sunrise Medical authorized dealer or
Sunrise Medical Customer Service.
TABLE 1
JAY FIT 2U
Back Width*
Width of back canes from outside
to outside of the tubes (A)
Minimum width
Maximum width
inch
cm
inch
cm
10-in
9.7
24.6
12.3
31.2
12-in
11.7
29.7
14.3
36.3
14-in
13.7
34.9
16.3
41.3
16-in
15.7
40.0
18.3
46.4
18-in
17.7
45.1
20.3
54.5
20-in
19.7
50.1
22.3
56.5
Cane Diameter (B)
Minimum width
Maximum width
inch
cm
inch
cm
3/4
1.9
1 1/8
2.85
* Back Width is identifi ed in your back part number. Example: part
number JFIT2UB1618HD is a 16-in wide back.
JAY FIT 2U COMPONENTS
3
4
TABLE 2
3
A
A
4
B
Locking Pin
10mm Box End Wrench
5mm Hex Key
HD Hardware
FP Hardware
5/8-in Box End Wrench
Outer Cover
Shell
Outer Cover
Foam
Inner
Cover
Positioning
Inserts
Only available as a
spare part.
Summary of Contents for FIT 2U BACK
Page 34: ...253633 Rev A 34 NOTES ...
Page 35: ...253633 Rev A 35 NOTES ...
