Jay electronique Jump, Installation And User Manual

Page: 12 / 28

- 40 -
Jump
- 332970D
FR DE EN
4.2.5- Learning transmitter identity code
The repeater Jump can only operates with a single «Transmitter / Receiver»
pair. It is therefore necessary for the repeater to «learn» the transmitter
identity code.
The repeater
Jump memory can only store one identity code.
For this procedure, the repeater must be con fi gured with the same radio
channel as the transmitter.
The learning procedure is performed using the DIPswitch « con fi guration »
and cursor No. 4.
Learning procedure of the transmitter identity code :
1.
Turn off the repeater Jump .
2.
Place the cursor No. 4 on «ON» position.
3.
Turn the repeater Jump .
4.
The LEDs LD2 and LD3 fl ash continuously and synchronously. The
repeater is waiting for a radio message.
5.
Emit radio frames using the transmitter to be associated (send a «Start /
Horn» signal, or command).
6.
LD2 and LD3 LEDs fl ash alternately. The identity code is stored.
7.
Place the cursor No. 4 on «OFF» position.
A
B
LD5
CONFIGURATION
TENS UNITS
LD2
LD3
LD4
CONFIGURATION
1 2 3 4 5 6 7 8
CONFIGURATION
«ON» position = Learning the transmitter
identity code
«OFF» position
cursor No. 4
1 2 3 5 6 7 8
ON