16
www.javad.com
BITS =8
PARITY =NONE
FLOW =HARDWARE
STOPBIT =0
DTR =0
RS =RS232
DATATX =UART
DATARX =UART
BUF =0
MPORT
The MPORT is an object that responsible for main-
tenance serial port interface configurations such as
data rate and number of bits in a byte.
MPORT [Parameter Name] [Parameters List] [/?]
Parameter
Name
Parameter List
RATE
0 – Auto
1 – 1200 baud
2 – 2400 baud
3 – 4800 baud
4 – 9600 baud
5 – 14400 baud
6 – 19200 baud
7 – 38400 baud
8 – 57600 baud
9 – 115200 baud, a default setting
Note:
JAVAD GNSS radio modem’s does not support data
flow and parity on the maintenance serial port. The radio mo-
dem with none-dedicated maintenance serial port must keep
CTS line always active in MPORT mode (DP/MP is low).
Special Commands
BOOT
The factory software image and default configuration
is set for the new unit. The BOOT command is intend-
ed to reboot the unit using specified software image
and selected configuration.
BOOT IMAGE BOOT CFG
The BOOT command with no parameters selects the
user settings defined by the prior “parameterized”
BOOT commands.
HELP
The HELP command types the list of all available
commands:
HELP- Display this usage
BOOT- Reboot the unit
LINK- Set RF Link Operation Mode
DPORT- Set Data Port Configuration
MPORT- Set Maintenance Port Configuration
ALARM- Alarm Indication and Alarm Control Con-
figuration SLEEP- Set Sleep Mode Configuration
STATE- Display Status and Statistics
SAVE- Save Current Configuration into Config-
uration File
INFO- Display Product ID along with Hardware/
Software Versions
ATI- Display Product ID along with Hardware/
Software Versions
MAP- Operates with Channel Map
DATAMODE- Exit Command Mode
[COMMAND] /?- Display Command Usage
SAVE
The SAVE command is intended to store the unit’s
currently used configuration into the User Configura-
tion file. The configuration stored in the User Config-
uration file is activated by automatically after unit’s
reboot.
SLEEP
The SLEEP command determines the sleep mode pa-
rameters. The sleeping AW435BT can be activated by
real-time CLK, DTR/RTS lines, and command received
through TTL inputs. The user can select one, two, or
all three conditions.
SLEEP [Parameter Name] [Parameters List] [/?]
Parameter
Name
Parameter List
CLK
0 – Do not activate by internal real-time clock
(1 – 255) – Activate by internal real-time clock
after 100 to 25500 msec of sleeping
HW
0 – Do not activate through DTR/RTS lines
1 – Activate through DTR/RTS lines
TTL
0 – Do not activate by external sense lines
1 – Activate by external sense lines
GTS
0 – Disable Sleep mode (default)
(1 – 255) – Go to sleep mode if there is no activity
in 10 to 2550 msec
