10
www.javad.com
Specifications
PHYSICAL INTERFACES
Serial Data Interface
- The serial asynchronous interface allows connection to external serial devices. It is
shared between user data and unit’s command/status information. All commonly supported baud rates, par-
ity and bit configurations are available up to 115.2 kbps.
Power Interface
- The power interface allows connection to an unregulated DC power source. The DC power
source (third-party or user supplied) must provide DC power of 4.0V±5% DC.
The standalone unit’s RF interface is a 50-ohm impedance matched standard MMCX connector as required by
regulation.
Antennas
- Antenna type depends on the site requirements, and may be directional or omni-directional.
Note:
To support 8 miles distance range between Base sta-
tion and SS unit, an antenna mast should elevate the base an-
tenna a minimum of 20 feet above the average level of the ter-
rain.
GENERAL SPECIFICATION
• Input Voltage: 3.6 V ± 5 %
• Power Consumption (average):
1 W – receive mode
• Temperature range:
Operation -40
o
F ... 140
o
F (-40
o
C ... +60
o
C)
Storage -40
o
F... 176
o
F (-40
o
C ... +80
o
C)
• Dimensions:
3.18 x 1.80 x 0.29/0.37 in (80.8 x 45.7 x 7.4/9.4
mm)
• Weight: 43 g
FEATURES
• DSP-Modem
• Zero-IF Technologies
• 406-470 MHz
• 902-928 MHz (USA); 915-928 MHz (Australia);
• 868-870 MHz (EU) with 25/20/12.5 kHz CS
• Up to 115200 bps Serial Interface Data Rate
• Embedded Firmware Compensation for Operation at
Extremely Low and High Temperatures
• Compact Design
EXTERNAL CONNECTORS
• RF Connector: J2 is Antenna Input / Output Connector:
MMCX RIGHT ANGLE PCB JACK, AMPHENOL P/N 908-
24100.
• Main Connector - 285209LF CONN, 16LEAD, HEADER,
5.84CONT COMM CON INC 3913-16G2
UHF RADIO SPECIFICATIONS
• Frequency Range: 406 - 470 MHz
• Channel Spacing: 25/20/12.5/6.25 kHz
• Carrier Frequency Stability: ±1 ppm
• Modulation GMSK/4FSK/DBPSK/DQPSK/ D8PSK/
D16QAM
• Communication Mode: Simplex
• Supported User Interfaces: Serial Asynchronous (TTL
compatible)
• Supported Comms. Protocols: Transparent Receiver
RADIO RECEIVER SPECIFICATIONS
• Receiver Sensitivity for DBPSK (BER 1x 10-4):
-113 dBm for 25 kHz Channel Spacing
-113 dBm for 20 kHz Channel Spacing
-114 dBm for 12.5 kHz Channel Spacing
-114 dBm for 6.25 kHz Channel Spacing
• Receiver Sensitivity for DQPSK (BER 1x 10-4)
-110 dBm for 25 kHz Channel Spacing
-110 dBm for 20 kHz Channel Spacing
-111 dBm for 12.5 kHz Channel Spacing
-111 dBm for 6.25 kHz Channel Spacing
• Receiver Dynamic Range: -119 to -10 dBm
• Data Rate of Radio Interface (25/20/12.5/6.25 kHz Chan-
nel Spacing):
9600/7500/4800/2400 bps – DBPSK/GMSK
19200/15000/9600/4800 bps – DQPSK
28800/22500/14400/7200 bps – D8PSK
38400/30000/19200/9600 bps – D16QAM
