www.javad.com
Maxor Operator’s Manual
2-35
C O N F I G U R A T I O N
Radio Configuration
6. Click the
Serial Interface
tab and select a baud rate for the
modem’s serial port. The same rate must be used for both the
receiver and the modem.
7. Click
Apply
, then click on
File
and select
Disconnect
. If you want
to close the program, click
File->Exit
.
8. Start PCView and set up the receiver to run as an RTK Base
Station. For how to set up an RTK Base using PCView, refere to
“Setting up an RTK Rover” on page 3-18 and
PCView Software
Manual
.
Warning:
When finished configuring the radio modem, always
disconnect from Modem-JNS before exiting to prevent
conflicts with serial port management.
Configuring a Base Station’s internal GSM/GPRS integrated
with 2W UHF transceiver with Modem-JNS
1. Repeat steps 1-4 described on page 2-27.
2. Click the
GSM
Figure 2-27. GSM Tab
3. In the
Mode
control, select
Slave
.
4. In the
PIN
field, enter a
Personal Identification Number
(PIN) if
required.
5. For the base station, leave the
Dial
field blank.
Summary of Contents for Maxor
