Command Line Interface
Diagnostics and Identification Commands
STATE
36
www.javad.com
Product ID =34
S/N =000000000007
Hardware =Ver. 1.0
Software =Ver. 1.6 Rev 12 B9
BootLoader =Ver. 2.0 Rev 01
3.5.2. STATE
The STATE command is used to check the state of the wireless link, the unit in the link, and the
alarm control lines. To specify a radio unit (local or remote), the CONNECT command must be
used in prior of STATE command using.
STATE [Parameter Name] [Parameters List] [/?]
The STATE command without Parameter Name indicates all values as shown below:
RSSI =-106 dBm
BER =0E-0
FREQ =440.000000 MHz
CHAN =-4
TEMP =23
SYNC =0
TTL1 =1
TTL2 =1
MODE =FIXED
Parameter Name
Parameter List
TTL1
0/1 - State of TTL_IN1 line
TTL2
0/1 - State of TTL_IN2 line
RSSI
-52 to -116 dBm - Indicates the Receive Signal Strength in dBm
BER
1.0E-6 to 9.9E-3 - Indicates the BER level
FREQ
138.000000 to 174.000000 MHz - Displays the central frequency of the operating
channel.
