13
Maximum power function:
• In this function you can set the operating time, but you can not adjust the temperature, since it is fixed.
• Press “
Preset tiempo
”. The display will start blinking.
• Press “+ or -” to adjust.
• Once the time has been set, it will be fixed in a few seconds. The display will stop blinking.
• You can stop the operation by pressing “
Pausa
”.
• To resume, press again.
• It must be taken into account that the device will automatically switch off after passing the time shown in the
display once pressed “
Pausa
”.
• To turn off the unit press and disconnect it from the network.
• If an error code appears on the display, refer to the table:
Trouble code
Possible Reasons
Solutions
E0
- No pot/pan on the plate;
- Non-usable Pans on the plate.
- Diameter of Pot is smaller than 120 mm.
Put suitable cooking utensils on the plate.
E1
- IGBT Electrocircuit mulfunction.
- IGBT sensor is in open circuit or in short
circuit.
Please contact the supplier or go to a
qualified service center.
E2
- Temperature sensor failure (in open circuit
or in short circuit).
Please contact the supplier or go to a
qualified service center.
e3
- Abnormal supply voltage: voltage too low
(<80V).
Please check power supply, power on after
power supply is back to normal.
e4
- Abnormal supply voltage: voltage too
high (>280V).
Please check power supply, power on after
power supply is back to normal.
e6
- Plate surface temperature too high.
- Empty pot/pan heating leads to too high
temperature.
Please wait for some minutes until the cools
down.
Please check pot/pan.
E7
- Thermal resistor doesn’t work.
Please contact the supplier or go to a
qualified service center.
- When E3 or E4 appears, device will automatically stop heating but do not shut down.
- When other Trouble Code appear, device will automatically stop heating and shut down.
You could press function to restart the device and eliminate the Trouble Code.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning, unplug the appliance from the mains and wait until the plate is totally cold.
• You can clean the body with a slightly dampened cloth.
• To clean the plate it is enough to use a slightly dampened cloth with soap. You also can clean the plate with
special products to clean vitro ceramic plates.
• If there are some hard residues you can use a scraper suitable for vitro ceramic hobs.
• Do not use abrasive or chemical products, metallic scourers, and such may deteriorate the surfaces.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
01 manual jata VIN145.indd 13
27/03/17 12:34
