background image

Jason International, Inc.  •  

 

501.771.4477  

 

 

 

Page 12 of 12

 

 

 

 

Customer Service :  800.255.5766 

IMPORTANT SAFETY INSTRUCTIONS

INsTruCTIONs  PerTaININg  TO  The  rIsK  Of  fIre,  eleCTrIC  shOCK,  Or  INJurY  TO 

PERSONS.

This manual contains information and instructions for proper operation and maintenance of your Air-Whirlpool bath.  Failure to 

follow these instructions could result in personal injury, electrical shock, or fire.

WARNING:  When  using  this  unit,  basic  precautions  should  always  be  followed,  including  the 

following:

reaD aND fOllOw all INsTruCTIONs CarefullY

DaNger:

 

TO reDuCe The rIsK Of INJurY fOllOw These PreCauTIONs: 

A.

  Do not permit children to use this product unless they are closely supervised at all times.

B.

  Use  this  unit  only  for  its  intended  use  as  described  in  this  manual.  Do  not  use  attachments  not  recommended  by  the 

manufacturer.

C.

  The water in an Air-Whirlpool should never exceed 40°C (104°F). Water temperatures between 38°C (100°F) and 40°C (104°F) 

are considered safe for a healthy adult. Use time should be limited to approximately 30 minutes, followed by a shower to cool 

down. Longer exposures may result in hyperthermia. The symptoms of this condition are nausea, dizziness and fainting, and 

it can be fatal. Lower water temperatures are recommended for extended use (exceeding 10 -15 minutes) and for young 

children.

D.

  Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy, 

pregnant or possibly pregnant women should limit whirlpool water temperatures to 38°C (100°F).

E.

  The  use  of  drugs  or  alcoholic  beverages  before  or  during  Air-Whirlpool  use  may  lead  to  unconsciousness  with  the 

possibility  of  drowning.  never  use  the  Air-Whirlpool  bath  while  under  the  influence  of  alcohol,  anticoagulants,  stimulants,  

antihistamines, vasoconstrictors, vasodilators, hypnotics, narcotics, or tranquilizers.

F.

  Persons with a medical history of heart disease, low or high blood pressure, circulatory system problems, or diabetes should 

consult a physician before using an Air-Whirlpool.

G.

  Persons using medication should consult a physician before using an Air-Whirlpool bath since some medication may induce 

drowsiness while other medication may affect heart rate, blood pressure, and circulation.

DaNger:

 

 

To reduce the risk of injury, enter and exit the bath slowly. 

do not operate this unit unless the suction cover is attached over the suction inlet fitting and the jet assemblies are installed.  

There should be at least two (2) inches of water above the highest jet location during Air-Whirlpool bath operation.

 NeVer ruN 

UNIT DRY.

warNINg:

 

Never operate electrically connected devices in or near the bath. Never drop or insert any object into any opening.

This unit must be connected to a supply circuit that is protected by a GFCI. Such a device should be installed by a licensed 

electrician and should be tested on a regular basis (at least monthly). To test the GFCI push the 

TesT

 button. The GFCI should 

interrupt the power. Push the 

reseT

 button and the power should be restored. If the GFCI fails to operate in this manner, there 

is the possibility of an electric shock. 

DO NOT use. 

disconnect the unit and have the problem corrected by a qualified service 

technician. 
To avoid the possibility of personal injury and discoloration of the acrylic surface, the inlet water temperature should not exceed 

40°C (104°F). The bath should be drained after each use. Each bather should start their bath with fresh water. Do not use oil 

base additives in your Air-Whirlpool bath.

CauTION: 

Do not use harsh abrasives or solvents for cleaning this unit.

INsTaller/OwNer Bears all resPONsIBIlITY TO COMPlY wITh all sTaTe  

AND LOCAL CODES WHEN INSTALLING THIS PRODUCT.

saVe These INsTruCTIONs

 

Jason InternatIonal, Inc.

8328 MacArthur Drive  •  North Little Rock  •  Arkansas  •  72118

www.jasoninternational.com 

Summary of Contents for forma Series













Reviews: