Jason International, Inc. · 501.771.4477 Page 5 of 12 Customer Service: 800.255.5766
Copyright © 2021 Jason International, Inc.
INTRODUCTION
This manual contains all of the information needed for
the proper installation and operation for your
Excel™
bath. The bath has been designed to give you years of
relaxing trouble-free service, provided the unit is
maintained and operated in accordance with these
instructions.
Thoroughly clean and disinfect the unit as described in
the
CLEANING
section of the
USER MAINTENANCE
INSTRUCTIONS
section of this owner’s manual before
its first use and periodically thereafter.
CAUTION:
Keep hair, towels and clothing away from
any installed suction fitting whenever the equipment is
ON. Never operate the equipment with the suction
cover off, doing so voids the manufacturer’s warranty—
it is a safety cover designed to eliminate the potential of
hair and body entrapment.
All Jason
Excel™ baths are pre-plumbed at the factory.
WARNING: Before operating, refer to the
instructions at the beginning of this owner’s manual
pertaining to the risk of fire, electric shock or injury
to persons.
Filling and Draining
Close the drain and fill the bath with water to the
desired level (at least two (2) inches (50mm) above the
jet). The inlet temperature should not exceed 104°F
(40°C). When bath is in use, turn the unit OFF before
draining the water. The bath unit and its plumbing are
designed to drain after each use whether used as a
hydrotherapy bath, soaking bath, or just taking a
shower.
NOTE:
If the unit fails to operate, check the breaker
panel to ensure that the circuit breaker is on. Check the
GFCI by testing and resetting it. If the unit still fails to
operate, refer to the Trouble Shooting Guide section of
this manual. If the unit still fails to operate and is out of
warranty, contact an authorized service technician for
repair. If the unit is within the warranty period, contact
JASON Technical Services at 800-255-5766
. DO NOT
ATTEMPT TO RESOLVE THE PROBLEM.
WHIRLPOOL FEATURES
Whirlpool Pump
Whirlpool pumps provided on Jason baths are factory
tested after installation on the bath. The pumps are of
efficient design incorporating high quality long life seals
which provide superior service. However, should the
pump need service; suction and discharge unions are
provided for easy pump removal.
Whirlpool Jets
Strategically placed whirlpool jets are provided for
complete enjoyment of your bath. The jets are specially
designed for maximum whirlpool action with directional
capabilities. By changing the direction of the jets, you
can concentrate the massaging jet stream to your area
of preference. You can also individually adjust the flow
of each jet.
Air ON/OFF Button
The Air On/Off button (air
switch activator) provides
a safe and convenient
method for controlling the
Whirlpool bath. The Air
On/Off button is factory
mounted onto the bath
prior to shipment. To operate, fill the bath to at least
two (2) inches above the jets and press the Air On/Off
button to start or stop the whirlpool pump.
FEATURES, CONTROLS AND OPERATING INSTRUCTIONS
