Jason International, Inc. •
501.771.4477
Page 12 of 25
Customer Service : 800.255.5766
Copyright © 2018 Jason International, Inc.
FEATURES, CONTROLS AND OPERATING INSTRUCTIONS (cont.)
The WHIRLPOOL icon is used to activate the
whirlpool pump and the 20-minute timer.
•
Once pressed, the whirlpool pump will start and
and “WP ON” will be displayed.
•
Pressing the icon again will shut the pump OFF
and “WP OFF” will be displayed.
•
Starting the Whirlpool pump will turn OFF any
other therapy equipment running at that time.
The PILLOW icon is used to activate the neck
jets when the Jetted Neck Pillow option is or-
dered. This icon will appear once the Whirlpool pump
has been activated.
•
CONSTANT flow from the neck jets will start with
the first press and “PILLOW ON” will be dis-
played.
•
PULSE Mode will start with the next press, indi-
cated by “PILLOW PULSE1” displayed.
•
ALTERNATING Mode will start with the next
press, indicated by “PILLOW PULSE2” displayed.
•
Pressing the icon again will turn the neck jets
OFF and “PILLOW OFF” will be displayed.
•
Once the system returns to Standby mode, a
timer will begin for the purge countdown. After
sixty (60) minutes the solenoids will open for two
(2) minutes to allow the plumbing lines to drain.
The AIRMASSEUR icon is used to activate the
blower and the 20-minute timer.
•
CONSTANT Mode will start with the first press and
“CONST AIR” will be displayed.
•
WAVE Mode will start with the next press and
“WAVE AIR” will be displayed.
•
PULSE Mode will start with the next press and
“PULSE AIR” will be displayed.
•
Pressing the icon again will shut the blower OFF.
•
Starting the AirMasseur will turn OFF any other
therapy equipment running at that time.
•
Once the system returns to Standby mode, the purge
timer will be displayed. After twenty (20) minutes
the blower will turn on for two (2) minutes to allow
the air channel to dry. This will be indicated with
the “PURGE ON” display. This purge cycle can be
canceled by pressing and holding the AIRMASSEUR
icon for five (5) seconds.
The SPEED icon is used to increase or decrease
the blower speed once the blower is ON.
•
Press and hold the icon to decrease the blower
speed until the desired intensity is reached, then
release.
•
Press and hold the icon again to increase the blower
speed until the desired intensity is reached.
•
The LCD will display the blower speed from “10”
(Low) to “99” (High) while the icon is pressed.
•
You can reduce the auto purge idle time from 20 min-
utes to 10 minutes, by pressing and holding the icon
for more than 5 seconds during the purge idle period.
WHIRLPOOL Icon
AIRMASSEUR
®
Icon
PILLOW Icon (optional)
Blower SPEED Icon
