1
General safety instructions
1
Failure to follow these instructions can endanger life!
Only authorised electricians are permitted to work on the
power connections of the wireless timer and all other elec-
trical work. All work must comply with the wiring diagrams
provided in these instructions (see page 2).
Always disconnect the power prior to installing or connecting
any electrical equipment.
Any work on electrical equipment carries the risk of fatal injury
from electric shock.
Observe the regulations regarding installation in damp areas.
In particular, observe DIN VDE 0100, section 701 and 702 when
using in damp areas. These regulations contain compulsory protec-
tive measures.
Use of defective equipment can cause a hazard for persons and
material damage (electric shock, short circuit)
Never use defective or damaged units.
Check the motor and mains cable for any damage.
Please refer to our Service Team (see last page), if you find any
damage to the equipment.
Please instruct all personnel on how to use the radio receiver
safely.
Improper use may lead to an increased risk of injury.
Observe the moving roller shutters and keep all personnel
clear until the shutter’s movement is completed.
Do not allow children to play with fixed controls or the remo-
te control.
Keep the hand transmitter in such a way to prevent any acci-
dental operation, e.g. by children playing.
When cleaning the roller shutters, make sure to disconnect
the power.
IMPORTANT
In accordance with DIN EN 13695, care must be taken to ensure
that the movement conditions established for roller shutters as
per EN12045 are observed, therefore with side locking.
Shutter curtain slats with locking mechanisms are available at
www.jalousiescout.de.
Correct use / operating conditions
Use the tubular motor only to open and close roller shutters
and awnings.
The motor cable must be laid in an empty conduit as far as the
junction box, in accordance with local electrical regulations.
Only use the manufacturer’s original components and acces-
sories.
Conditions for use
For electrical connection, the installation site must have a
constant 230 V / 50 Hz electricity supply, with a main circuit
disconnect device (fuse) on site.
IMPORTANT
Important installation instructions
IMPORTANT
Before assembly, compare the voltage / frequency information on the type label with that of the local electricity network.
Prior to installing the timer, please remove all wires and devices that are not necessary for operation, or shut the devices down.
After unpacking, compare the following:
contents of package and the delivery information in these instructions.
the type of motor and the corresponding information on the type label.
