PROGRAMMING
17
To set the end positions of the controlled radio drive and for further settings or programming steps, you need the instructions
for the respective radio motor or external radio receiver!
Initial programming TDRC04
The example shown is exemplary and depends on the respective receiver type. Please refer to the instructions of the receiver!
NOTE: Each key must be pressed (held) for approx� 1 second!
Each programming step must take place within approx� 10 seconds�
Otherwise, the system automatically exits the programming mode� If necessary, start from the beginning�
1. First select the desired channel to which the receiver is to be programmed using the channel selection button (for descrip-
tion see page 5) (the active channel is indicated by the lit LED in the lower part of the handheld transmitter).
ATTENTION! Programming in the “group control” setting (all LEDs lit) is NOT possible!
2. Set the desired radio receiver or radio motor to programming mode in accordance with the relevant instructions.
programming mode.
3. Within approx. 10 seconds, press the up and down buttons of the hand-held transmitter simultaneously.
4. Then immediately press the stop button on the hand-held transmitter.
As an alternative to pressing the up, down and stop buttons, you can also use the programming button on the back of the hand-
held transmitter. hand-held transmitter (option 2 - depending on the model).
5. Successful teach-in is acknowledged by a short vibration of the tubular motor connected to the radio receiver or the vibrati
on of the radio motor.
Possibility 1:
Desired Channel
(1-4) via Channel
selection key to
select.
Receiver according
to instructions to
the learning mode
according to the
instructions.
(engine vibrates)
Up/down button
simultaneously
press, then imme-
diately press the
stop key Press the
stop button.
Possibility 1:
Desired Channel
(1-4) via Channel
selection key to
select.
Receiver according
to instructions to
the learning mode
according to the
instructions.
(engine vibrates)
Programming
button (rear
side) with a
biros or a small
screwdriver
briefly press.
If you want to control more receivers with this transmitter/channel, repeat the procedure.
ATTENTION!
Check the function with the UP/STOP/DOWN buttons on the hand-held transmitter.
If the direction of rotation of the motor is incorrect (roller shutter / motor moves downwards when the UP button is pressed),
the direction of rotation of the motor must be changed.
Please refer to the chapter “Changing the direction of rotation” of the respective radio motor or radio receiver�
max. 10 sec.
max. 10 Sek.
