JARLTECH 8010T, Operation Manual, Page: 13 / 52

13
Preparation for Programming
Step 6: Confirm RS232 pin assignments
Step 7: Turn on your computer
Please ensure that the RS232 pin assignments on your
computer confirm with the pin assignments of the HOST port
on the Jarltech keyboard:
Pin #1: +5V Pin #7: RTS
Pin #2: RX Pin #8: CTS
Pin #3: TX Pin #9: +12V
Pin #5: GND
The pin assignments of all keyboard ports are found in the
specifications listed in Appendix I.
Once all connections are complete, turn on your computer. It
should boot up normally. The keyboard will "beep" three
times.
The keyboard is now ready for programming. Turn to
Chapter 3.
If you haven’t done so already, turn off your computer to
avoid any accidental damage to the keyboard. Refer to the
keyboard installation shown in Diagram 2.2.
Unplug the 101/102 keyboard cable from your computer. Plug
the 101/102 keyboard cable into female side of the T-connec-
tor on the Jarltech keyboard cable. Plug the male end of the
T-connector into the keyboard port of your computer.
Be sure that no peripheral device are connected to the
AUX1RS232 port on the Jarltech keyboard. Once all connec-
tions are complete, turn on your computer. It should boot up
normally. The keyboard will "beep" three times.
The keyboard is now ready for programming. Turn to
Chapter 3.
Programming via the Keyboard Port