DAY BED
WARNINGS:
1. ANY MATTRESS USED IN THIS DAY BED MUST BE AT LEAST 27-1/4" × 51-5/8" (69CM
× 131CM) WITH A MINIMUM THICKNESS OF 4" AND NOT EXCEEDING 6" (15CM).
2. THE DAY BED IS INTENDED FOR USE BY A CHILD NOT LESS THAN 15 MONTHS
OF AGE AND WHO WEIGHS NO MORE THAN 50LBS (27.7KG)
NOTE: WHEN INSERTING SCREWS, TURN CLOCKWISE UNTIL TIGHT, THEN LOOSEN
1/2-3/4 OF A TURN, AFTER CRIB IS COMPLETELY ASSEMBLED, RETURN TO EACH
SCREW AND TIGHTEN. USE WAX OR SOAP ON ALL SCREWS TO FACILITATE ASSEMBLY.
DAY BED ASSEMBLY INSTRUCTIONS, STARTING FROM CRIB
STEP 1:
UNSCREW THE RUBBER BUMPER STOP (PART E) FROM THE LOWER DROPSIDE
TRACK ON THE LEFT (PART K1) AND RIGHT (PART K2) FRONT POSTS.
STEP 2:
DETACH THE DROPSIDE (PART M) FROM THE LEFT AND RIGHT POSTS BY SLIDING
THE UPPER AND LOWER GUIDES ON EACH END OF THE DROPSIDE DOWN UNTIL
THEY ARE BELOW THE UPPER AND LOWER DROPSIDE TRACK. ONCE THE
DROPSIDE HITS THE FLOOR, THE GUIDES AND TRACKS CAN BE SEPARATED
FROM EACH OTHER.
STEP 3:
UNSCREW AND DETACH THE LOWER TRACKS FROM THE LEFT AND RIGHT FRONT
POSTS.
STEP 4:
IF MATTRESS SUPPORT (PART P) IS NOT IN THE LOWEST POSITION,UNSCREW
MATTRESS SUPPORT BOLTS (PART D) FROM POST AND MOVE IT TO THE LOWEST
POSITION.
STEP 5:
USING THE WRENCH PROVIDED, ATTACH THE GUARD RAIL (PART N)
USING 4 BOLTS (PART A) BETWEEN THE LEFT AND RIGHT FRONT POSTS.
STEP 6:
TIGHTEN ALL SCREWS CLOCKWISE.
STARTING FROM SCRATCH:
STEP 1: FOLLOW STEPS 1 TO 4 OF THE CRIB ASSEMBLY INSTRUCTIONS.
STEP 2: FOLLOW STEPS 3 TO 6 FOR THE DAY BED ASSEMBLY INSTRUCTIONS LOCATED
ABOVE (STARTING FROM CRIB).
NOTE:
PLEASE ENSURE THAT THE HEIGHT ADJUSTMENT HOLES BE FILLED
WITH SCREWS (D) AFTER THE MATTRESS SUPPORT HAS BEEN MOVED TO THE
LOWEST LEVEL. MAKE SURE THAT THESE SCREWS ARE TIGHTLY SECURED.
K2
L
K1
N
A
G
A
O