6
Operating instruction
Congratulations to your new cookie machine.
1. Unpacking the machine
If you find a damage on the unpacked machine, call your agent and let him see the
damage, so that the damaged machine can be replaced.
2. Connect the machine
Before plugging the machine, get sure, that electricity network has a voltage
of 3 x 400V + MP + protective conductor. the machine is set by this specifcation.
With 3 x 230 + MP + protection manager, the engine of the machine is reversed ac
-
cordingly. If you have the correct voltage with the appropriate socket, you can let the
machine run on trial basis. If the machine is running backward, stop the engine imme
-
diately and disconnect the power plug from the can.The machine is wired clockwise. It
is banned to manipulate the clockwise rotation of connection.
Let, if necessary, your socked change by a licensed electrician!
If the machine is permanently connected without a firm plug, the machine needs an
additional main switch.
3.1. Beltregulation / upper transport belt
The upper transportbelt, wich takes the figures from the knife, can be adjusted by hex
nut M18 on spindle thread on both sides. Please regulate only few and do not tighten
the belt too fast, because the belt takes some minutes to regulate.
If possible take always just one side to regulate, because otherwise the tension of the
belt greatly increases unnecessarily. The belt gets narrow and snatches in extreme
rase.
3.2. Beltregulation / lower tranport belt
The lower transport belt must not be adjusted.
They are connected by connectors and can be exchanged easily.
4.1. Speed regulation of transport belt
The speed of the lower transport belt can be in connection with the speed of the ma
-
chine, regulated by Selectroniccontrol.
