to 160-250°C (set the temperature according to the material and thickness of the foil/film,
the thicker the foil/film, the higher the temperature is). The average temperature is
180°C .
The sealing time can be adjusted in PLC, adjust the time according to the sealing effect.
The filling volume can be adjusted by the valve.
When operating the machine, check the working condition such as running of the spare
parts, the fixing of the screws, air pipe connection. If anything wrong, stop the machine
immediately and fix it, then restart the machine.
When the temperature reaches the setting temperature, put the cups into the cup mould,
install the film on the film set or put the foils in the foil setting system, turn the rotary
board, the indicating light is on, the machine is on automatically filling and sealing, the
finished products should be taken out manually.
IV. Installation and Adjustment
1.
After opening the package, check the spare parts first to make sure you get all the parts.
Check the screws tight or loose, check the operation of the parts.
2.
Adjust the temperature according to the thickness of the film/aluminum foil. Adjust
the volume by the cylinder valve. The temperature time and sealing time can be
adjustable.
V. Maintaining
1.
Check the air source pressure before running, the average air pressure should be 0.6-
0.7Mpa. To insure the good working of the cylinder, drain the waste water in thefilter
regularly.
2.
After working, let the heating part cool on room temperature. Clean the filling tank
with hot water and drain the water. Clean the aluminum board to prevent corrosion and
aging.
3.
Clean the heating part to better the sealing effect.
4.
Connect the machine earth wire properly to safe using.
5.
Set the sealing temperature from low to high to insure the sealing temperature more
even and better sealing effect.
6.
Stop the machine immediately when breakdown happens, the whole machine is on reset
condition, shut down the power and check the breakdowns. After fixing, restart the
machine.
