Janome TM30, Instruction Book

Page: 34 / 52

32
z
Use the same procedure as the memory buttonhole
sewing (refer to pages 29-30). Set the stitch width to
match the thickness of the cord used.
With the buttonhole foot raised, hook the filler cord on
the spur at the back of the buttonhole foot. Bring the
ends toward you under the buttonhole foot, clearing
the front end.
Hook the filler cord into the forks on the front of the
buttonhole foot to hold them tight.
Lower the needle into the garment where the
buttonhole will start, and lower the foot.
q
Spur
w
Forks
e
Cord
x
Start the machine and sew the buttonhole.
Each side of the buttonhole and the bartacks will be
sewn over the cord.
Remove the fabric from the machine, and cut the
sewing threads only.
e
Cord
r
Needle thread
t
Bobbin thread
c
Pull the left side of loose end of the filler cord to
tighten it. Trim the excess filler.
NOTE:
Cut the filler cord at both ends, if the filler cord is
stitched on the fabric and cannot be pulled.
Corded Buttonhole
q
Stitch pattern: 17
w
Thread tension dial: 1 to 4
e
Presser foot: Sliding buttonhole foot
4
w e q
z
x
c
e
w
q
e
r
t