48
START
STOP
MACHINE SETTINGS
Machine Setting Mode
In the setting mode buzzer sound and needle stop
position can be set to your preference.
Entering the setting mode
Turn the power switch on while pressing and holding the
thread cutter button. Keep the thread cutter button
pressed until the LCD screen shows the buzzer setting
mode (01onoF).
q
Thread cutter button
Buzzer sound setting
The default setting is ON and “on” sign is blinking.
Press the “+” sign of the stitch length adjusting button to
turn off or turn on buzzer.
Each time you press the button “oF” and “on” signs
blink alternately.
w
Stitch length adjusting button
Press the auto-lock button to save the new setting and
return to the normal sewing mode.
e
Auto-lock button
Or press the thread cutter button to go to the needle stop
position setting mode (02UPdn).
r
Thread cutter button
Needle stop position setting
The default setting is DOWN and “dn” sign is blinking.
Press the “+” sign of the stitch width adjusting button to
select the needle stop position up or down.
Each time you press the button “UP” and “dn” signs
blink alternately.
t
Stitch width adjusting button
Press the auto-lock button to save the new setting and
return to the normal sewing mode.
NOTE:
If you turn off the machine without pressing the auto-lock
button, the new setting will not be saved.
q
w
e
t
Correcting Deformed Stitch Patterns
The sewing results of stretch stitch patterns may vary
depending on sewing conditions, such as sewing speed,
fabric type, number of layers etc.
If stretch stitch patterns are deformed, correct them by
turning the feed balancing dial with the screwdriver.
If the pattern is compressed, turn the dial in the direction
of “+”.
If the pattern is drawn out, turn the dial in the direction of
“–”.
q
Feed balancing dial
(+)
(–)
q
r
