24
Button Sewing
q
Stitch pattern:
C
w
Stitch width:
Adjust as necessary
e
Stitch length:
Any
r
Thread tension:
3 – 7
t
Presser foot:
Buttonhole foot B
y
Feed dog:
Lowered
y
q
w
e
q
w
e
r
t
z
x
c
z
Unthread the needle. Adjust the stitch width
to match it with the span of the holes in the
button. Turn the handwheel to check if the
needle enters into each hole in the button.
Lower the foot to hold the button in place.
The holes in the button should align with the
slot of the foot.
x
A pin can be placed on the foot to form a
shank.
Make sure to check if the needle enters into
both holes in the button.
q
Pin
Re-thread the needle and sew about 10
stitches and cut the needle and bobbin
threads at the beginning.
c
Raise the presser foot and remove the fabric.
Cut the needle and bobbin threads leaving 8˝
(20 cm) tails.
Bring the needle thread between the button
and fabric through the holes in the button.
Pull the needle thread to pick bobbin thread
up to the right side of the fabric.
Wind the threads to from a shank and tie
them together.
w
Needle thread
e
Bobbin thread
NOTE:
Raise the feed dog after sewing.
Summary of Contents for Sewist 725s
