Janome Sewist 725s, Instruction Book

Page: 12 / 52

8
Changing Needles
CAUTION:
Always make sure to turn the power switch
off and disconnect the machine from power
supply before changing the needle.
Raise the needle by turning the handwheel and
lower the presser foot.
Turn off the power switch.
z
Loosen the needle clamp screw by turning it
counterclockwise.
Remove the needle from the clamp.
q
Needle clamp screw
Removing and Attaching the Foot Holder
WARNING:
Turn OFF the power switch before detaching
or attaching the foot holder.
To remove:
Remove the setscrew by turning it
counterclockwise with a screwdriver and remove
the foot holder.
To attach:
Match the hole in the foot holder with the
threaded hole in the presser bar. Fit the setscrew
into the hole. Tighten the screw by turning it
clockwise with a screwdriver.
q
Setscrew
w
Foot holder
e
Hole
r
Threaded hole
q
w
e
r
q e
q
w
x
Insert a new needle into the needle clamp
with the flat side of the needle to the rear.
When inserting the needle into the needle
clamp, push it up against the stopper pin and
tighten the needle clamp screw firmly.
q
Needle clamp screw
w
Flat side
e
Stopper pin
z
x