36
MC 9500
Adjusting X and Y Sensors (Simple Adjustment)
To adjust X and Y sensor (without removing the base unit):
1 Remove the base cover.
2 Remove the presser foot holder and place the fabric
on the Embroidery hoop (A) .
Attach the Embroidery foop (A) on the carriage.
(Place the Template on the Embroidery hoop as
shown.)
3 Turn the power switch “ON” and select the Embroidery
Mode, then select the pattern No.1 on the touch panel.
4 Check if the Needle goes into the Hole in the
Template .
5 Turn the power switch “OFF”.
6 If the needle drop position is slightly out of position in
the Y-direction, loosen the Screw (A) and move
the Y-sensor fixing plate to adjust.
If the needle drop position is slightly out of position in
the X direction, loosen the Screw (B) through the
hole of the Sheet cover fixing plate hole , and
move the X shield plate to adjust.
7 Turn the power switch “ON”
Select the Embroidery Mode and select the pattern
No.1 on the touch panel, then check if the needle goes
into the center of the Hole in the
template .
8 Return the carriage to the stored pposition, then turn
the power switch “OFF”.
9. Remove the Template and the Embroidery hoop
, then install the base cover.
Embroidry hoop
Template
Needle
Hole in the template
Screw (A)
Y-Sensor fixing plate
Screw (B)
Hole of the sheet cover fixing plate
X- Shield plate
X- direction
1
2
3
4
5
4
2
1
2
3
4
8
8
7
6
5
9
1
2
3
4
5
6
7
8
9
1
2
6
7
8
9
10
1
X
Y
10
11
11
Y- direction
www.promelectroavtomat.ru
