WHEN THE MACHINE IS SET FOR ZIGZAG STITCH-
ING, THE NEEDLE SHOULD START TO ZIGZAG 8.0
MM TO 8.4 MM (C = HEIGHT OF ZIGZAG FOOT)
ABOVE THE SURFACE OF THE NEEDLE PLATE.
1 SET THE MACHINE FOR ADJUSTING MODE BY
TURNING THE POWER SWITCH WHILE PRESS-
ING THE NEEDLE UP/DOWN AND THE LOCK
STITCH BUTTONS AT A TIME.
THEN PRESS THE NUMBER 4 BUTTON WITHIN
3 SECONDS (IF IT IS NOT PRESSED WITHIN
3 SECONDS, THE MACHINE WILL RETURN TO
NORMAL SEWING MODE).
2 TURN THE HANDWHEEL TOWARD YOU SLOWLY
WITH YOUR HAND UNTIL THE NEEDLE COMES
8.2 MM ABOVE THE SURFACE OF THE NEEDLE
PLATE.
3 REMOVE THE MACHINE BASE.
LOOSEN THE SETSCREW (D) AND TURN THE
SHIELD PLATE (E) UNTIL THE ìBsenî ON THE LCD
CHANGES FROM [L] TO [H] AND BUZZER
SOUNDS.
TIGHTEN THE SETSCREW (D).
4 SET THE RIGHT SIDE OF THE SHIELD PLATE TO
THE CENTER OF THE SENSOR AS SHOWN IN
THE FIG. 1 AND TIGHTEN THE SET SCREW (G).
5 TURN THE BALANCE WHEEL TOWARD YOU, AND
CHECK THE CLEARANCE BETWEEN THE LEFT
SIDE OF THE SHIELD PLATES AND SENSORS.
(THE SHIELD PLATES AND SENSORS SHOULD
NOT TOUCH.) ALSO, CHECK THAT ìCsenî
CHANGES FROM [L] TO [H] AT THE LOWEST
NEEDLE POSITION.
6 ATTACH THE MACHINE BASE.
8.0 - 8.4 MM (C)
ZIGZAG FOOT
NEEDLE,
SIZE 14
SHIELD PLATE (E)
SETSCREW (D)
SETSCREW (G)
ZIGZAG SENSOR (F)
FEED SENSOR
AUTO THREAD
CUTTER SENSOR
SETTING
PLATE
0.5–1.5 MM
SHIELD PLATE
SHOULD NOT TOUCH.
SENSOR
SHIELD PLATE (E)
FIG. 1
TO ADJUST ZIGZAG TIMING
35
Summary of Contents for MC6600
Page 1: ...Revised on October 20 2005...
