TO ADJUST THE UPPER FEED DOG (2)
1 ATTACH THE DUAL FEED FOOT.
2 SET THE UPPER FEED DOG. TURN THE POWER
SWITCH ON. SELECT THE MODE 1, THEN SELECT
THE STITCH #1 ( ).
3 PRESS THE STITCH LENGTH ADJUSTING KEY.
SET THE STITCH LENGTH TO 0.
4 LOWER THE FEED DOG.
5 SET THE UPPER FEED DOG ADJUSTING DIAL TO
ì0î.
6 LOWER THE PRESSER FOOT. CHECK THE
CLEARANCE BETWEEN THE DUAL FEED FOOT
AND UPPER FEED DOG. THE CLEARANCE
SHOULD BE 4 MM.
ADJUSTMENT
IF THE CLEARANCE BETWEEN THE DUAL FEED
FOOT AND UPPER FEED DOG IS NOT 4MM,
FOLLOW THE PROCEDURE BELOW.
7 REMOVE THE TOP COVER.
8 LOOSEN THE SETSCREWS (A).
9 ADJUST THE UPPER SHAFT REAR ARM SO THE
CLEARANCE BETWEEN THE DUAL FEED FOOT
AND UPPER FEED DOG IS 4MM.
10 ATTACH THE TOP COVER.
UPPER SHAFT REAR
ARM (UPPER FEED)
UPPER FEED DOG
DUAL FEED FOOT
4 MM
UPPER FEED DOG ADJUSTING DIAL
SETSCREW (A)
UPPER FEED DOG
FEED DOG
NEEDLE PLATE
28
4 MM
(GAUGE 846-G01)
Summary of Contents for MC6600
Page 1: ...Revised on October 20 2005...
