MECHANICAL ADJUSTMENT
PRESSER BAR HEIGHT AND ALIGNMENT
CORRECT SETTING
THE STANDARD PRESSER BAR HEIGHT IS 6.0 mm BETWEEN THE BOTTOM SURFACE OF THE
FOOT AND NEEDLE PLATE WHEN PRESSER FOOT LIFTER IS UP POSITION.
TO ADJUST
1.
REMOVE THE FACE PLATE. (SEE PAGE 4.)
2.
REMOVE SET SCREW A AND REMOVE LAMP HOLDER SET PLATE.
3.
PAISE THE PRESSER FOOT AND LOOSE PRESSER BAR BRACKET SCREW AND ADJUST
THE HEIGHT (6.0mm).
4.
CHECK IF THE PRESSER FOOT IS PARALLEL TO THE OPEINIGS FOR THE FEED DOG ON
THE NEEDLE PLATE. IF NOT, ADJUST IT.
5.
TIGHTEN THE PRESSER BAR BRACKET SCREW WHILE HOLDING THE PRESSER BAR TO
KEEP THE FOOT PALALLEL TO THE OPENINGS.
6.
ATTACH THE LAMP HOLDER SET PLATE.
7.
ATTACH THE FACE PLATE.
6.0 mm
PRESSER FOOT
NEEDLE PLATE
OPENING
TO BE PARALLEL
PRESSER BAR
BRACKET SCREW
PRESSER FOOT
LIFTER
SET SCREW A
PAMP HOLDER SET PLAE
9
www.promelectroavtomat.ru
