Janome Harmony 8100, Instruction Book

Page: 35 / 63

33
Darning
q
R: Automatic buttonhole foot
z
Pull the button holder to the rear.
x
Place the garment under the presser foot. Press the
up/down needle button key twice to pull up the
bobbin thread.
Remove the fabric to the left to draw both threads
under the presser foot and put the fabric under the
foot again.
c
Place the needle where you would like to sew and
lower the foot. Press the foot control.
The machine will lock stitch, sew 16 rows of
darning, lock stitch and stop automatically.
The machine will lock stitch, sew 16 rows of
darning, lock stitch again and stop automatically.
* The size of darn cycle is variable. However, the
maximum stitch length is 2 cm (3/4˝) and the
maximum stitch width is 0.7 cm (1/4˝).
w
Button holder
e
Foot hole
r
Starting point for darning
t
2 cm (3/4˝)
y
0.7 cm (1/4˝)
[For darning a length of less than 2cm (3/4˝),]
v
For darning a length of less than 2 cm.
First stop the machine after sewing the desired
length and then press the reverse button. The
required length has now been determined. Now,
restart the machine and continue sewing until the
machine stops automatically.
b
Turn the fabric to change the sewing direction for
repeat sewing from step 1 to 3.
u
Reverse key
i
Length required
o
Starting point for darning
[To memorize darning stitches:]
When you press the memory key after step 3 and 4
you can repeatedly sew the samesize darn to repair a
side rip.
[To adjust the balance of the darning stitches.]
If one side of the darn is higher or lower than the
other, make them even by pressing the “ – ” or “ + ”
key between 1 and 5.
!0
Stitch width, Stitch length key
!1
When the left side is lower
!2
Select “ 1 ” or “ 2 ” to balance the stitches.
!3
When the right side is lower
!4
Select “ 4 ” or “ 5 ” to balance the stitches.
!5
This indication will be shown when you press the
Memory key.
,
,
,
,
q
w
e
t
y
r
u
i
o
!0 !5
!1 !2 !3 !4
z x c
v b