12
• Spool Holder (special)
Use the spool holder (special) when using a long spool of
thread as shown.
e
9.5 - 10.5mm (3/8 - 7/16 inch)
r
70 - 75mm (2-3/4 - 3 inch)
Attach the spool holder (special) by inserting it into the
hole of the spool of thread. Make sure there is no gap
between the spool holder and the spool of thread.
t
Spool holder (special)
y
No gap
e
e
t
r
y
q
q
q
w
e
w
w
e
Bobbin Winding
• Removing the bobbin
Gently slide the hook cover release button
q
to the
right and remove the hook cover plate
w
.
Lift out the bobbin.
q
Hook cover release button
w
Hook cover plate
• Horizontal spool pin
Lift up the spool pin
q
. Place a spool of thread on the
spool pin.
Attach the large spool holder
w
, and press it firmly
against the spool of thread.
The small spool holder
e
is used with narrow or small
spools of thread.
Lower the spool pin
q
.
q
Spool pin
w
Large spool holder
e
Small spool holder
• Additional spool pin
The additional spool pin
q
is for winding bobbins
without unthreading the machine.
Insert the additional spool pin
q
into the hole
w
.
The additional spool pin should point to the bobbin
winding tension disk
e
.
q
Additional spool pin
w
Hole for additional spool pin
e
Bobbin winding tension disk
