42
Preseer foot height on needle plate adjustment
To adjust:
1. Turn the power switch on while pressing the start/stop
button and reverse button to enter the factory setting
mode.
Press the “Foot Up/Down” key to select the Foot Up/
Down adjusting mode.
2. Attach the foot holder lightly (Do not tighten the
thumbscrew firmly.).
3. Press the “Down” key. The presser bar will be
lowered.
Tighten the thumbscrew firmly.
4. Press the “Init” key to initialize the settings.
Press the “Adjust” key to lower the foot.
Check if there is a space between the foot and needle
plate by tapping the foot tip with fingers as shown.
If there is not enough space to tap the foot tip,
press “–” few times to raise the presser bar, giving
a enough space between the needle plate and the
presser foot.
5. Press the “+” once and tap the foot to check the
space.
Repeat this step until the tapping sound is gone.
6. Press the “+” again to apply foot pressure, then
press the “set” to register the presser bar height.
* Adjust the presser bar height always by pressing “+”
key.
Do not press “–” at the end of this adjustment.
In case “+” button pressed too many times, press
“–” few times and return the step 4 above.
* The value of “Adjust Step” should be within the
range of 970 to 1030. If the value is far out of the
range, check Automatic Presser Foot Lifter Sensor
adjustment.
* Turn the power switch ON again to enter the
ordinary sewing mode, and set the presser foot
pressure to “Auto-5”. Press the presser foot button
to lower the presser foot. Be sure that there is a
clearance between the presser foot lifter stopper
and the automatic presser foot lifter lever as shown
in the picture.
If there is no clearance between the presser foot
lifter stopper and the automatic presser foot lifter
lever, adjust the presser bar height again.
Reverse button
Start/stop button
Presser foot lifter stopper
Tap
Clearance
Automatic
presser foot
lifter lever
Presser foot lifter button