12
15. Needle Threader (1600P only)
To remove:
[1] Remove the face plate.
[2] Pull the threader (1) out from the threader shaft (2).
To attach:
[3] Align the groove (3) of the theader with the pin (4) on
the threader shaft. Push the threader up until it snaps
in place.
To adjust:
[1] If the threader hook (1) thrusts or hits against either
left or right edge of the needle eye (2):
Loosen the setscrew (3). Move the threader plate (4)
to adjust the lateral position of the threader hook (1).
[2] If the threader hook (1) thrusts or hits against either
top or bottom edge of the needle eye (2), or misses
the needle eye (2):
Loosen the setscrew (5). Move the threader position
setting plate (6) up or down to adjust the vertical
position of the threader hook (1).
(1)
(2)
(3)
(5)
(4)
(6)
(1)
(2)
(1)
(2)
(3)
(4)