Scope of supply
Number
Designation
1
MRG 96RM-E Flex RCM
1
Supplementary description MRG 96RM-E Flex RCM
1
Operation manual UMG 96RM-E
1
Carry case
1
Power supply 24 V DC
3
Voltage pickoffs with fuses, black (gripping probes)
1
Voltage pickoff with fuse, blue (gripping probe)
1
Voltage measurement set (brown, black, grey, red, blue)
4
Rogowski coil with connection cable and plug (
ø
95 mm, L 300 mm)
1
Cross patch cable, CAT 5e
2
Connection cable with plug for residual current measurement, 3 m
(Residual current transformer not included in the scope of deliverables)
Concerning this operation manual
This description and the operating instructions for
the device are part of the product.
• Read this description and the operation manual
through prior to using the device.
• Keep this description and the operation manual
throughout the complete service life of the
product and have them readily available for
reference.
• Pass this description and the operation manual
on to each subsequent owner or user of the
product.
• In the event of questions that are not covered
by this operation manual for the UMG 96RM-
E, please contact the support department of
Janitza electronics GmbH (Tel. no. +49 6441-
9642-22).
This device must only be operated and repaired
by specialised personnel.
Connecting the measurement case
1.
Connect the power supply to the measurement
case
(1)
and connect the power supply to 230 V
/ 50 Hz.
2.
Carry out basic settings on the UMG 96RM-E
(2)
, e.g.
- Voltage transformer / current transformer
settings
- Recording configuration or
- RCM measurement
(the transformer for RCM measurement is not
included in the scope of deliverables).
The settings can be implemented via the
accompanying GridVis software or directly
on the UMG 96RM-E (see the accompanying
instructions for the UMG 96RM-E for this).
3.
Set up the measurement transformer
(3)
- see
"Measurement transformer configuration"
chapter.
4.
Connect measured voltage with the voltage
tap-offs via the voltage inputs
(4)
or with the
measurement lines included in the scope of
deliverables. In doing so, observe the applicable
safety regulations.
5.
Connect current transformer coils (operating
current
(5)
or residual current
(6)
) with the
measurement case via the screw terminals.
6.
Connect the current transformer coils to the
consumer to be measured.
7.
Measurement starts
- 4 -
